Populate the MultiView Panel

Populate the MultiView Panel :

When the Tree Node contains more than one camera it is possible to use the polulate MultiView command,

the command automatically loads all the cameras present in the selected group into the MultiView Panel

the Layout will depend on the number of cameras present in the Group if the number is less or equal to four

the (2 x 2) Layout will be selected, if the number is greater than four but less or equal to nine the (3 x 3)

Layout will be selected, if the Group contains more than Nine Cameras the (4 x 4) Layout is used.

A Group will not Populate if it contains more than 16 Cameras.

To access the Populate command use the Context Menu from the selected Tree Node as shown in figure 1

the first voice in the menu will perform the population task.

figure 1

This help file has been generated by the freeware version of HelpNDoc